Welcome to our Mining equipment manufacturing base, Contact Us


Ankit Nileshchandra Patel 1, Prof. Jayeshkumar Pitroda 2438 Кб. In India, stone dust is settled by sedimentation and then dumped away which results in environmental pollution, in additionStone waste can be used as a partial replacement of cement or replacement of fine aggregate and as a supplementary addition to achieve different properties of concrete.


replacement of the fine aggregate with stone dust % of fine aggregate replaced with stone dust Compressive Strength (N/mm2) 3 days 7 days 28days 0% 17 19.1 61 10% 18 20 62 20% 21 23 64 30%` 25 28 68 40% 28 34 72 50% 23.5 30 60 Figure 1: Variation of Strength due to % of fine aggregate replacement with stone dust


In this study, marble stone dust (MSD) and wood saw dust (WSD) were used as partial replacement for cement and fine aggregate in concrete mix respectively. The test samples were prepared by replacing 0%, 2%, 4%, and 6% of cement and fines by weight of concrete with MSD and WSD.


The results were compared for concretes with natural sand to that of quarry stone dust as fine aggregate. 2.7.1 COMPRESSIVE STRENGHTS (M25 GRADE): The compressive strength of M25 grade concrete cubes made with natural sand and those made with quarry stone dust as fine aggregate are tested under compression testing machine and results are ...


Experimental programme was conducted using 30%, 40%, 50%, 60% and 70% partial replacement of fine aggregate with stone dust has been taken for concrete of M25 grade with 0.46 water cement ratio.


to study the effect of partial replacement of fine aggregates by quarry dust and cement by fly ash on cement concrete. 1.2 NEED FOR INVESTIGATION Quarry Dust These residues are generally less than 1% aggregate production in the normal concrete. The introduction of quarry dust for mixing is limited due to its high fineness.


Apr 19, 2021· Agbede, A. J. (2002) Suitability of Quarry Dust as Partial Replacement for sand in Hollow Block, Nse Technical Journal, Vol. 46, No., pp22 -28. British Standard Institution BS 882, Part 2: 1973. Coarse and Fine aggregate from National Sources, London. Ducatz, E. L. (1995) Effective use of Aggregate Fine ICAR 3rd Annual Symposium.


Answer (1 of 3): Yes you can replace some amount of fine aggregate with quarry dust but before adding the quarry dust you should follow some guideline's 1. Avoid addition of quarry dust if have no experience or little experience in concrete technology. Use …


Sep 12, 2013 ... cement, fine aggregates (i.e. Sand) and 12.5 mm size aggregates with and ... replacement of stone dust with 2% Superplasticizer is equal. Get Price partial replacement of fine aggregate in concrete in ppt


I'm not an authority on this subject, but here are some thoughts. That depends upon what the quarry dust is. If it has minerals that will react with the cement you could get a faster or slower set time. Also, since quarry dust is quite fine, you s...


period of 7 and 28 days .The result indicated effectiveness of stone dust as fine aggregate and partial replacement of conventional coarse aggregately vitrified scrap up to percent, without affecting the design strength. In the present study, Ceramic tile waste were used in concrete as a replacement for natural coarse


stone dust as partial replacement of fine aggregate in concrete. To accomplish this specimen were cast for different replacement level at an interval of 10 percent to determine workability and compressive strength of concrete at different level of fine aggregate with stone dust. The percentage of stone dust was gradually


other is Stone dust. The Fly as his used as 20% replace by weight of cement and Stone Dust as the partial replaceme nt of Fine Aggregate from 0%, 10%, 20%, 30% and 40%. The grade of the concrete here is M-30 grade. Keywords: fly ash, Stone Dust, Mix Design, Compressive Strength Test, Flexure Test, Split Tensile Test INTRODUCTION


Jun 12, 2013· Stone dust can become partial replacement for sand after due testing of the … avuthu narender Reddy · Bapatla Engineering College … material which will replace coarse aggregate and fine aggregate, since day by ….. size of aggregate is specified by the consultant,or is specified in the project …


Corpus ID: 212600892. EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CEMENT WITH MARBLE POWDER AND FINE AGGREGATE WITH QUARRY DUST @inproceedings{Abhilash2017EXPERIMENTALSO, title={EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CEMENT WITH MARBLE POWDER AND FINE …


Experimental Investigation on the Concrete as a Partial Replacement of Fine Aggregate with Stone Dust and Brick Dust P Kalyani1 EV Raghava Rao2 1P.G. Student 2Professor 1,2Department of Civil Engineering 1,2Visakha Technical Campus, Narava, Visakhapatnam, A.P., India Abstract—This project work involves in an experimental


aggregate as partial replacement of fine aggregate. Materials and methods given in Methodology: Experimental investigation was conducted to get the strength of specimens (cubes and beams) made with the use of stone dust and recycled aggregates as partial replacement of fine aggregates and coarse aggregates respectively.


using stone dust as partial replacement of fine aggregate in the range of 10% - . M25 grade of concrete was designed using Portland pozzolana cement (PPC) for referral concrete. Workability and Compressive strength were determined at different replacement level of fine aggregate viz a viz referral


of fine aggregate and recycled aggregate as partial replacement of coarse aggregate. In the present study cubes and beams were cast to determine the compressive and flexural strength of concrete made using stone dust and recycled aggregate as replacement of natural aggregate.


the control mix prepared in accordance to the mix design and in other four mixes partial replacement of fine aggregate by stone dust was carried out in percentages of 40%, 50%, 60% and 70% respectively. The ingredients were first mixed in dry condition.


Hence replacement of coarse aggregate with 30% shabath stone was achieved good strength. 5. REFERENCE [1]. Veera Reddy.M "Investigations on stone dust and ceramic scrap as aggregate replacement in concrete", International journal of civil and structural engineering Volume 1, No 3, (2010), [2]. Rifath Sharmin, .


Dec 08, 2015· This Paper Presents the experimental study undertaken to investigate the influence of partial substitution of cement(opc) with Fly ash (FA), and partial substitution of fine aggregate by marble ...


ash (FA), and partial substitution of fine aggregate by marble dust (MD) and stone dust(SD). Fly ash is a by product of burnt coal from the Thermal power plants, Marble dust is a waste product from marble industries and stone dust is a waste product from crusher plants.


Quarry dust as partial replacement of sand in concrete. Design mix of M20 grade concrete with replacement of 0%, 20%, 30%, 40%, and 50% of quarry dust organized as M1, ... the possibility of using crushed stone dust as fine aggregate partially or fully with different grades of concrete composites. The suitability of crushed stone dust waste as


quarry dust to be used as partial replacement material for fine aggregate in SCC and curing compound (Concure WB) for self-curing of SCC. It was found the mechanical properties gave maximum strength for natural sand replaced by quarry dust up to 40% for both water cure and self-cure as compared to that of Normal SCC with water cure and self-cure.


The aggregate gives 1. Replacement of fine aggregate by quarry dust at partial volume, stability, resistance to wear or erosion, and other replace results the increase in strength of concrete. desired physical properties to the finished product. 2. The concept of replacement of natural fine aggregate III.


Replacement of Fine Aggregate with Stone (Quarry) Dust Y.Anand Babu ... partial replacement of natural sand. However, scarcity in required quality is the major ... 01 Fine Aggregate Stone Dust (Replaced) Sand (Actual) 02 Specific Gravity of Fine Aggregate


Aug 12, 2020· The present paper study the effect of partial substitution of brick dust (BD), stone dust (SD), and recycled fine aggregate (RFA) as fine aggregate on the properties of natural aggregate concrete (NAC) and recycled aggregate concrete (RAC). ... respectively, when the replacement of NFA with BD and SD in both NAC and RAC.


Partial Use of stone dust in concrete as an alternative of sand 1. 1 2 3 3 Partial Use of stone dust in concrete as an alternative of sand ABSTRACT . Stone dust produced from stone crushing zones appears as a problem for effective disposal. Sand is a widely used fine aggregate used in construction work.


Feb 10, 2021· Singh S K, Srivastava V, Agarwal V C, Kumar R, Mehta P K. An experimental investigation on stone dust as partial replacement of fine aggregate in concrete. Journal of Academia and Industrial Research, 2014, 3(5): 229–232. Google Scholar 18. Cheah C …


The compressive strength of specimens (100mm cubes) cast for different proportions of stone dust was determined and compare the same with referral concrete. The result showed that the stone dust can effectively been used as partial replacement of natural fine aggregate without compromising the compressive strength.


consists of a partial replacement of fine aggregate with stone dust in cement concrete for rigid pavement. In this project she has added stone dust in cement concrete mix. Here stone dust is added in cement concrete mix with a percentage variation of 5%, 10%, 15%, 20% and 25%. By adding stone dust


Oct 15, 2016· The Glass Powder is used as 20% replacement of the cement and Stone Dust as the partial replacement of Fine Aggregate from 0%, 10%, 20%, 30% and 40%. The grade of the concrete here is M25 and M30 grade. Slump Test was carried out for the fresh concrete whereas Compressive Strength, Flexure Strength and Split Tensile Tests were carried for the ...


Mar 08, 2017· M 25 grade of concrete is prepared with high volume fly ash in concrete with various proportions as a partial replacement of cement 0%, 10%, 20%, 30%, 40%, 50% of opc and quarry rock dust is used as partial replacement of fine aggregates 0%, 10%, 20%, 30%, 40%, 50% by river sand.


The replacement level of fine aggregate varied between 30-70% at an interval of 10%. Materials and methods Experimental design: An experimental investigation was conducted to get the strength of specimen (cube and beam) made with the use of stone dust in partial replacement of fine aggregate. The strength of conventional concrete and other ...